2001 SeaDoo GS, GTI, GTS, GTX, GTX RFI, RX, XP, RX DI, GTX DI Operator's Guide

2001 SeaDoo GS, GSX RFI, GTS, GTI Operator's Guide Contents:

FOREWORD SAFETY MEASURES General Operation Maintenance LIST OF DISTRIBUTORS BOMBARDIER LIMITED WARRANTY NORTH AMERICA: SEA-DOO(R) WATERCRAFT BOMBARDIER INTERNATIONAL LIMITED WARRANTY: SEA-DOO(R) WATERCRAFT REGISTRATION NUMBER LOCATION LOCATION OF THE IMPORTANT LABELS IDENTIFICATION NUMBERS Hull Engine CONTROLS, COMPONENTS AND INSTRUMENTS LOCATION CONTROLS, COMPONENTS AND INSTRUMENTS FUNCTIONS 1) Safety Lanyard (engine cut-off cord) 2) Handlebar 3) Throttle Lever 4) Engine Start/Stop Button 5) Variable Trim System Button (VTS) (if so equipped) 6) Variable Trim System (VTS) Gauge (if so equipped) 7) Choke Lever 8) Shift Lever (if so equipped) 9) Fuel Gauge/Low Oil Warning Light (if so equipped) 10) Speedometer (if so equipped) 11) Tachometer (if so equipped) 12) Information Center Gauge/Buttons (if so equipped) 13) Glove Box 14) Fuel Tank Valve 15) Fuel Tank Cap 16) Oil Injection Reservoir Cap 17) Front Storage Compartment Cover 18) Front Storage Compartment Cover Latch 19) Front Storage Compartment Cover Hinge/Locking Mechanism 20) Front Storage Compartment Cover Lock (if so equipped) 21) Storage Compartment/Engine Cover Latches (if so equipped) 22) Tool Kit 23) Air Intake Opening 24) Seat Strap 25) Seat Latch 26) Seat Extension Latch (if so equipped) 27) Rear Grab Handle 28) Rear Storage Basket (if so equipped) 29) Rear Access Cover (if so equipped) 30) Bow and Stern Eyelets 31) Mooring Cleats 32) Fender Cleats (if so equipped) 33) Footboard 34) Boarding Pads 35) Boarding Platform 36) Boarding Step (if so equipped) 37) Cooling System Bleed Outlet 38) Flushing Connector (if so equipped) 39) Bilge Drain Plugs 40) Automatic Bilge Pump (if so equipped) 41) Jet Pump Nozzle 42) Reverse Gate (if so equipped) 43) Jet Pump Water Intake 44) Fuses 45) Battery FUEL AND LUBRICATION Fueling Procedure Recommended Fuel Recommended Oil Oil Injection System BREAK-IN PERIOD 10-Hour Inspection PRE-OPERATION CHECKS Hull Jet Pump Water Intake Bilge Battery Fuel Tank and Oil Reservoir Engine Compartment Steering System Throttle System Shifter System VTS (Variable Trim System) (if so equipped) Storage Compartment Covers and Seat Safety Lanyard and Engine Start/Stop Button OPERATING INSTRUCTIONS Principle of Operation Boarding the Watercraft Starting Rough Water or Poor Visibility Operation Crossing Waves Stopping/Docking Beaching Shutting Off the Engine POST-OPERATION CARE General Care Additional Care for Foul Water or Salt Water Cooling System Flushing and Engine Internal Lubrication Anticorrosion Treatment SPECIAL PROCEDURES Monitoring System Limp Home Mode Engine Overheating Jet Pump Water Intake and Impeller Cleaning Capsized Watercraft Submerged Watercraft Water-Flooded Engine Fuel-Flooded Engine Out of Fuel Towing the Watercraft in Water Low-Charge Battery Condition MAINTENANCE Engine Emissions Information Lubrication Periodic Inspection Periodic Inspection Chart Throttle and Choke Cable Inspection Carburetor Adjustment Fuel Injection System Fuel and Oil Filters Steering Alignment VTS Adjustment (if so equipped) Vacuum Bailer Pick-Ups Fuses General Inspection and Cleaning TRAILERING, STORAGE AND PRE-SEASON PREPARATION Trailering Storage Pre-Season Preparation TROUBLESHOOTING SPECIFICATIONS SI METRIC INFORMATION ABBREVIATIONS USED IN THIS MANUAL CHANGE OF ADDRESS