2000 SeaDoo RX (5513,5514) Operator's Guide

2000 SeaDoo RX Operator's Guide Contents:

SAFETY WARNING General Operation Maintenance LIST OF DISTRIBUTORS BOMBARDIER LIMITED WARRANTY NORTH AMERICA 2000 SEA-DOO® WATERCRAFT BOMBARDIER INTERNATIONAL LIMITED WARRANTY 2000 SEA-DOO® WATERCRAFT REGISTRATION NUMBER LOCATION LOCATION OF THE IMPORTANT LABELS IDENTIFICATION NUMBERS Hull Engine CONTROLS AND COMPONENT LOCATION COMPONENTS FUNCTIONS 1) Safety Lanyard 2) Handlebar 3) Throttle Lever 4) Engine Start/Stop Button 5) Variable Trim System Button (VTS) (if so equipped) 6) Choke Lever 7) Shift Lever 8) Speedometer 9) Information Center Gauge/Buttons 10) Glove Box 11) Fuel Tank Valve 12) Fuel Tank Cap 13) Oil Injection Reservoir Cap 14) Front Storage Compartment Cover 15) Front Storage Compartment Cover Latch 16) Tool Kit 17) Air Intake Opening 18) Seat Strap 19) Seat Latch 20) Seat Extension Latch (if so equipped) 21) Rear Grab Handle 22) Rear Storage Basket (if so equipped) 23) Bow and Stern Eyelets 24) Mooring Cleats 25) Cargo Cleats (if so equipped) 26) Footboard 27) Boarding Pads 28) Boarding Platform 29) Cooling System Bleed Outlet 30) Flushing Connector 31) Bilge Drain Plugs 32) Jet Pump Nozzle 33) Reverse Gate 34) Jet Pump Water Intake FUEL AND LUBRICATION Fueling Procedure Recommended Fuel Recommended Oil Oil Injection System BREAK-IN PERIOD 10-Hour Inspection DAILY PRE-OPERATION CHECKS Hull Jet Pump Water Intake Bilge Battery Fuel Tank and Oil Reservoir Engine Compartment Steering System Throttle System Shifter System VTS (Variable Trim System) (if so equipped) Safety Lanyard and Engine Start/Stop Button Storage Compartment Covers OPERATING INSTRUCTIONS Principle of Operation Boarding the Watercraft Starting the Engine Rough Water or Poor Visibility Operation Crossing Waves Stopping/Docking Beaching Shutting Off the Engine POST-OPERATION CARE General Care Additional Care for Foul Water or Salt Water Cooling System Flushing and Engine Internal Lubrication Anticorrosion Treatment SPECIAL PROCEDURES Limp Home Mode Engine Overheating Jet Pump Water Intake and Impeller Cleaning Capsized Watercraft Submerged Watercraft Water-Flooded Engine Fuel-Flooded Engine Out of Fuel Towing the Watercraft in Water Low-charge Battery Condition MAINTENANCE Lubrication Periodic Inspection Periodic Inspection Chart Throttle and Choke Cable Inspection Carburetor Adjustment Fuel Injection System Fuel and Oil Filters Steering Alignment VTS Adjustment (if so equipped) Vacuum Bailer Pick-Ups Fuses General Inspection and Cleaning TRAILERING, STORAGE AND PRE-SEASON PREPARATION Trailering Storage Pre-Season Preparation TROUBLESHOOTING SPECIFICATIONS SI METRIC INFORMATION ABBREVIATIONS USED IN THIS MANUAL CHANGE OF ADDRESS