2000 SeaDoo LRV (5688) Operator's Guide

2000 SeaDoo LRV Operator's Guide Contents:

FOREWORD SAFETY WARNING General Operation Maintenance LIST OF DISTRIBUTORS BOMBARDIER LIMITED WARRANTY NORTH AMERICA 2000 SEA-DOO® WATERCRAFT BOMBARDIER INTERNATIONAL LIMITED WARRANTY 2000 SEA-DOO® WATERCRAFT REGISTRATION NUMBER LOCATION LOCATION OF THE IMPORTANT LABELS IDENTIFICATION NUMBERS Hull Engine CONTROLS AND COMPONENT LOCATION COMPONENTS FUNCTIONS 1) Safety Lanyard 2) Handlebar 3) Throttle Lever 4) Shift Lever 5) Engine Start/Stop Button 6) Choke Lever 7) Info Center Gauge/Switches 8) Speedometer 9) Fuel Tank Valve 10) Bilge Drain Plugs 11) Rear Grab Handles 12) Seat Strap 13) Swim Platform 14) Seat Latch 15) Cover Latch 16) Front Storage Compartment 17) Glove Box 18) Side Storage Compartments 19) Underseat Storage Compartments 20) Engine Compartment 21) Mooring Cleats 22) Oil Injection Reservoir Cap 23) Fuel Tank Cap 24) Deck Drains 25) Flushing Connector 26) Bow and Stern Eyelets 27) Jet Pump Nozzle 28) Reverse Gate 29) Scupper Valves 30) Cooling System Bleed Outlet(s) 31) Jet Pump Water Intake 32) Automatic Bilge Pump 33) Boarding Step 34) Sun Deck 35) Tool Kit FUEL AND LUBRICATION Fueling Procedure Recommended Fuel Recommended Oil Oil Injection System BREAK-IN PERIOD Engine 10-Hour Inspection DAILY PRE-OPERATION CHECKS Hull Jet Pump Water Intake Bilge Battery Fuel Tank and Oil Reservoir Engine Compartment Steering System Throttle System Shifter System Safety Lanyard and Engine Start/Stop Button Storage Compartment Covers OPERATING INSTRUCTIONS Trailering Principle of Operation Boarding from a Dock Boarding from the Water Starting the Engine Rough Water or Poor Visibility Operation Crossing Waves Stopping/Docking Beaching Shutting Off the Engine POST-OPERATION CARE General Care Additional Care for Foul Water or Salt Water Cooling System Flushing and Engine Internal Lubrication Anticorrosion Treatment SPECIAL PROCEDURES Engine Overheating Jet Pump Water Intake and Impeller Cleaning Capsized Craft Submerged Craft Towing the Craft in Water Low-Charge Battery Condition MAINTENANCE Lubrication Periodic Inspection Periodic Inspection Chart Throttle and Choke Cable Inspection Carburetor Adjustment Fuel and Oil Filters Steering Alignment Deck Drains Vacuum Bailer Pick-Ups Fuses General Inspection and Cleaning STORAGE AND PRE-SEASON PREPARATION Storage Pre-Season Preparation TROUBLESHOOTING SPECIFICATIONS SI METRIC INFORMATION ABBREVIATIONS USED IN THIS MANUAL OTHER PUBLICATIONS AVAILABLE CHANGE OF ADDRESS